BUILD TIME: 2 WEEKS.

Description:

The GigaPara is a parametric EQ and pre-amp pedal with 3 bell-curve parametric EQ bands, 2 parametric shelving bands and a range of input and output options.

GigaPara can accept balanced or unbalanced XLR, TRS or TS inputs (ie. a standard 1/4" instrument lead) and is designed to work with guitars, basses, microphones and line-level equipment.

This pedal is quite complex, so please take the time to read through the specifications and user manual so that you can make the best use of it.

Features:

•3 bell-curve parametric EQ bands with Frequency, Gain and Q controls (Frequency ranges are 20-400Hz, 150Hz-2.4KHz, 1KHz-16KHz, Gain of each band ranges from +/-15dB and Q factor ranges from 20-0.5).
•1 low-shelf filter ranging from 30-400Hz, and 1 high-shelf filter from 1.1-20KHz. Gain of each is +/-15dB.
•Choose between a 1 mega-ohm instrument input, a 4 kilo-ohm mic input or a 10 kilo-ohm line input.
•True/Active bypass switch. In Active mode, "IN GAIN" is retained to help keep mic levels constant (see below).
•"IN GAIN" control to apply gain to the input.
•Volume control ("OUT GAIN") with additional recovery gain of up to +10dB.
•Ground lift switch.
•-10dB pad for hot signals.
•Input: XLR or 1/4" TRS (accepts both balanced and unbalanced inputs).
•Output: Balanced XLR or unbalanced 1/4" TS.
•High-end, low-noise and low-distortion components.


Specifications:

•Input impedance:
◦Instrument: 1mega-ohm
◦Mic: 4 kilo-ohm
◦Line: 10 kilo-ohm
•Output impedance: 200 ohm
•Power supply (not included): 9-24V DC, centre-negative, 2.1mm barrel connector (18-24V recommended).
•Headroom:
◦24V supply: ~28dBu
◦18V supply: ~25dBu
◦9V supply: ~16dBu
•Dimensions: 80x120x70mm, including knobs (3.15x4.72x2.75").
•Noise: <-100dB

Shipping fee will be added at checkout. All orders are shipped on the next working day (immediately if there is ready-built stock when you place an order, or after completion if there is a build time). Click here for warranty info.

Unsure about something? Please read the FAQ or get in touch via. the email at the bottom of every page.

All pedals by Sine Effect Electronics are designed and built in Glasgow, Scotland. As these products are made completely by hand, there may be some slight visual imperfections that you wouldn't get from factory robots. Every effort is made to ensure that the pedals look cool and sound good, though!